
Lease start & end
Record the condition at move-in and at move-out, and settle the restoration conversation with a dated record.

Move-ins, move-outs, fit-outs and leaks all end with the same question: what was there before? Capture your building with your own team or have FrontView do it, then capture it again at every lease event. Every version is dated, measured and comparable, down to the boiler nameplate.
You don't need a 3D model. You need proof of what the space looked like, and when.

Record the condition at move-in and at move-out, and settle the restoration conversation with a dated record.

Document tenant improvements before, during and after, with measurements contractors can use.

A leak or a break-in? Compare against the last capture to show what changed.
Answer “how wide is that corridor?” from your desk, without sending someone to the site.
Give lenders, buyers and engineers one link that holds the building’s full history.
Invite owners, facilities, engineers and tenants, and set what each can see.
Schedule a recapture whenever you need one. Each becomes a new dated version, and FrontView shows the difference.
Stop at the electrical panel, the boiler or the rooftop unit, tap Add point and take close-ups. Each point is pinned where it sits, with nameplate and condition photos, and checked again at every capture.



Capture it with your own team using a kit, or have FrontView capture it as an add-on, facade & roof included. Once it's in, it stays in, and every recapture adds to it.